![]() ![]() Check the manufacturer’s instructions for how to set it up for suctioning water. A wet/dry shop vacuum empties toilet tanks and bowls quickly.If water comes from this opening then the toilet is leaking and has to be fixed. Leave a small opening in the back of the bowl facing the wall. If there are no leaks, you can now seal the toilet floor with caulk. To be on the safe side, keep checking for leaks after an hour and also the next day just to be sure that the wax ring is sealed properly.įurther Reading: Symptoms of a Leaky Toilet Wax Ring 11. Uninstall it and follow the installation process again. If you notice water on the tissues, the wax seal is not sealed properly. Place tissues around the toilet and flush the toilet severally. Turn on the water and let the tank fill before flushing the toilet. Reconnect the Toilet and check the Wax RingĪpply fresh plumbers tape to the tank inlet threads and attach the water supply line. Do not over-tighten the bolts because they might end up getting damaged or cracking the toilet bowl. Tighten the bolts a little at a time until the bowl is sitting firmly on the finished floor. Put back the bolts and washers in the order and location that they were removed. Use a side-to-side twisting motion until the toilet is resting on the finished bathroom floor. Hold the toilet as level as possible when placing it on the new wax seal. Reinstall the toilet by using the bolts as a guide. Place the new wax seal on top of the toilet flange and make sure it is centered. If the flange is in a good condition, proceed to the installation of the ring. Make sure the bolts are centered in with the toilet flange opening and parallel with the finished wall behind the toilet tank. If you are using the old bolts, make sure that they are in good condition. If you are replacing the old toilet bolts with new ones, put them in place now. repair it with a flange repair kit, if necessary. Inspect the Toilet FlangeĬheck the flange for cracks, decays and any other damage. Scrap of the caulk too on the toilet base and flooring too. Using a pair of waterproof cleaning gloves, scrap the wax seal off the base of the toilet and the toilet flange with a putty knife. If the toilet is too heavy to carry, you can remove the bolts attaching the tank to the bowl and move the two parts separately. Carefully lift it and place it on blocks. Grab the toilet under the sides of the bowl and rock it forth and back gently to break the old wax seal. Remove the nuts and washers from the bolts at the toilet base using the adjustable wrench. Use a flathead screwdriver to remove the caps that cover the bolts and the washers. ![]() Use a utility knife to score away all the caulking around your toilet base. This helps in resetting the toilet after the wax seal is replaced. Detach the Toiletĭetach the water supply line hose from the toilet fill valve and the 3/8 compression nut. You can also use a plunger to force down the remaining water in the bowl into the drain. Use a sponge or a water solidifier to temporarily solidify and water remaining in the bowl. Remove the toilet tank lid and flush the toilet as you hold the toilet handle down so that as much water as possible drains from the tank and bowl. Turn the water supply off by turning the valve in a clockwise direction. Here are a few steps on how to do that: 2. The tools and supplies required for replacement include īefore you install the new toilet wax ring, it is necessary to drain and remove the toilet. ![]() Do you have to Replace the Wax Ring when you Remove a Toilet? 1. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |